In a two lines converge. In an ascending triangle the highs hit a flat several times while the lows rise. In a symmetrical one the highs fall and the lows rise. The range narrows until the price closes above the upper line. From the width at the start, the , we calculate the targets.
What our detection checks
At least five touches of the lines, four are enough for the ascending triangle. The highs lie at most 0.5 apart or fall by at least 1 ATR, the lows rise by at least 1 ATR. At the start the triangle is at least 2 ATR wide, at the last point at most 70% as wide – it has to narrow visibly. For the symmetrical triangle, too, we only report the breakout upward.
The model, recalculated
Resistance 110.00, lows at 100.00, 103.43 and 106.00, ATR 2 in the model. At candle 70 the price closes above it for the first time at 110.52. Zone 110.00–111.00 (line up to 0.5 ATR above). Stop 105.00: lowest low since the last low minus 0.5 ATR. Target 1 = 110.00 + pattern height 10.00 = 120.00, target 2 = 110.00 + 1.618 × 10.00 = 126.18.
Textbook and our calculation
Textbooks use the pattern height as the target. We calculate it like this: target 1 with the simple height, target 2 with 1.618 times the height. For us the ascending triangle counts with four touches already, so that patterns seen in practice are not dropped. The pattern does not tell you whether the price reaches a target.
Guide: the triangle pattern step by step
The triangle is one of the most common chart patterns. In an ascending triangle the price hits the same resistance several times while the lows rise. In a symmetrical triangle the highs fall and the lows rise. In both cases the range narrows until the price breaks out.
Detection step by step
- Find turning points with a 1.5 ATR swing (daily chart). The last four to six form the triangle: at least two highs and two lows, neighbours at least 3 candles apart.
- Draw the lines: one through the first and the last high, one through the first and the last low. Every turning point lies at most 0.5 away from its line.
- Determine the shape. Ascending: the highs lie at most 0.5 ATR apart, the resistance is the highest high; every low is higher than the one before, together at least 1 ATR. Symmetrical: the highs fall and the lows rise, each by at least 1 ATR.
- Count the touches: at least five, four are enough for the ascending triangle. From five touches on, at least three lie on one line.
- Check the narrowing: at the start the triangle is at least 2 ATR wide, at the last turning point at most 70% as wide, at the breakout still at least 0.5 ATR.
- Check the length: 15 to 120 candles from the first to the last turning point; the breakout follows at most 25 candles later.
- Trigger: the first daily close above the upper line. After the last turning point no candle closes above the upper line, and no low falls more than 0.5 ATR below the lower one.
Zone, stop and targets
The zone runs from the upper line at the breakout up to 0.5 ATR above it. The stop lies 0.5 ATR below the lowest low since the last confirmed low – not just below the turning point itself, because an even lower low shortly before the breakout belongs to the pattern. The is the width at the start, measured where both lines already exist. Target 1 = line + pattern height, target 2 = line + 1.618 × pattern height. If target 1 lies less than 1 ATR above the zone, we do not report the triangle.
Worked example with model figures
Resistance 50.00, ATR 1.00. The highs lie at 50.00, 49.80 and 50.00, the lows rise from 45.00 via 46.50 to 48.00. At the start the triangle is 5.00 wide, at the last low 2.00 – that is 40%, clearly narrower. The first close above lies at 50.40. Zone 50.00 to 50.50. The lowest low since the last low is 48.00, so the stop lies at 47.50. Target 1 = 50.00 + 5.00 = 55.00, target 2 = 50.00 + 1.618 × 5.00 = 58.09. From the top of the zone it is 3.00 to the stop and 4.50 to target 1: a of 1.5.
False breakout and invalid triangles
A wick above the line without a close above it is not yet a breakout. If the price does close above it but then falls to the stop, the triangle no longer applies for us. The symmetrical triangle can also break down; we do not report that case. We show the descending triangle with flat lows and falling highs only as a warning pattern. If the lines do not converge, it is rather a channel or a range – then there is no triangle.
Volume
For the triangle, volume is not a condition for us. The checklist does show whether the volume at the breakout was at least 1.5 times the average of the previous 20 candles. Many traders watch this because a breakout on low turnover falls back more easily. The number of touches is shown there too: only from six does the checklist rate the shape as clean.
Timeframes
On 4H the same lengths in candles apply as on the daily chart. On the weekly chart it is 8 to 60 candles, and the breakout follows at most 13 weeks after the last turning point. The tolerances in ATR stay the same everywhere. Only the swing from which a turning point counts differs: 1 ATR on the weekly chart, 2 ATR on 4H. Zone, stop and targets on 4H and 1W are available from Premium.
Frequently asked questions
How reliable is an ascending triangle?
Nobody can say that for a single case. The shape shows that sellers keep waiting at one price while interested parties step in earlier. Whether the breakout holds only shows afterwards. There is no assurance. How often a pattern has reached target 1 before the stop so far, we show with Premium as a past figure – not as a forecast. Still plan the stop beforehand and work out the .
What is the difference between an ascending and a symmetrical triangle?
In the ascending triangle the upper line is flat and only the lows rise. In the symmetrical one the highs fall and the lows rise. For the breakout this means: in the ascending one the line always sits at the same price, in the symmetrical one it drops with every candle. We report both only on a breakout upward.
How do I calculate the price target of a triangle?
Measure the width of the triangle at the start, where both lines already exist. Target 1 is the breakout line plus this width, target 2 the line plus 1.618 times it. Textbooks usually give only the simple height; target 2 is our calculation. Targets are calculated values, not a promise.
How long does a triangle last?
For us 15 to 120 candles from the first to the last turning point, so on the daily chart roughly three weeks to half a year. Shorter shapes are often just noise, longer ones rather a broad sideways phase.
What happens if the price comes back after the breakout?
A pullback to the line (often called a retest) happens and is not a failure in itself. As long as the price closes up to the top of the zone, the status reads “in the zone”. If a low falls to the stop, the pattern no longer applies; if a high reaches target 1, it is also done.